How much does it cost to fix P0780?

Typical repair cost is $200–$2,500.

P0780 — Shift Malfunction

High Severity · Transmission

OBD-II code P0780 means your vehicle's ECU detected: Shift Malfunction. Below: causes, step-by-step fixes, and repair cost — free, no signup needed.

High severity — do not ignore. Get a diagnosis promptly to avoid further engine damage.

Typical Repair Cost

$200–$2,500

Parts + labor, national average

Severity

High

Address as soon as possible

🔍

Common Causes of P0780

Low ATF
Multiple solenoid failures
Internal damage

🔧

How to Fix Code P0780

Check ATF level first

Scan for all trans codes

Service transmission

❓

FAQ — Code P0780

What does OBD-II code P0780 mean?

P0780 means your vehicle's onboard computer detected: Shift Malfunction. This is a high-severity code in the Transmission category.

How much does it cost to fix code P0780?

Typical repair cost for P0780 is $200–$2,500 including parts and labor. Costs vary by vehicle make, model, and location. A free scan at AutoZone or O'Reilly is a good first step.

Can I drive my car with code P0780?

Code P0780 is high severity. Avoid long drives until diagnosed — continued driving can cause additional engine damage.

What are the most common causes of P0780?

The most common causes are: Low ATF, Multiple solenoid failures, Internal damage. Always start with the cheapest diagnosis step before replacing parts.

Will code P0780 clear itself?

Code P0780 will clear itself after the underlying issue is fixed and the ECU completes several successful drive cycles. Clearing it without fixing the root cause only masks the problem temporarily.

Is P0780 showing on your car?

Enter your VIN for a free vehicle-specific report — recalls, specs, and market value. No signup required.

🔗

Related Transmission Codes

P0700Transmission Control System Malfunction P0705Transmission Range Sensor Circuit Malfunction...P0711Transmission Fluid Temperature Sensor Range/Performance P0715Turbine/Input Shaft Speed Sensor Circuit P0720Output Speed Sensor Circuit Malfunction P0730Incorrect Gear Ratio

OBD-II code data is based on SAE J2012 standards and general repair industry data. Repair costs are national averages and vary by vehicle, location, and shop. Always consult a qualified mechanic for a diagnosis specific to your vehicle.